AR-M550/M620/M700 SIMULATION 8 - 44
Operation/Procedure
1) Select ENABLE/DISABLE of the CA key cancel function of print
stop with 10-key.
2) Press [START] key.
(Default: 1)
Operation/Procedure
1) Select the number corresponding to the operation mode with 10-
key.
2) Press [START] key.
(Default: 0)
Operation/Procedure
1) Enter the tag number with 10-key.
2) Press [START] key.
Operation/Procedure
The operating conditions of sensors and detectors are displayed.
The active sensors and detectors are highlighted.
26-68
Purpose Setting
Function
(Purpose)
Used to set ENABLE/DISABLE of the CA key cancel
function of print stop.
Section
Item Specifications Operation
0 DISABLE Disable
1 ENABLE (PRINT STOP) Enable
27
27-1
Purpose Setting
Function
(Purpose)
Used to set the specifications for operations in case of
communication trouble between the host computer and
MODEM (machine side). (When communication
trouble occurs between the host computer MODEM
and the machine, the self diag display (U7-00) is
printed and setting for inhibition of print or not is made.)
Section Communication unit (TEL/LIU/MODEM etc.)
Item Specifications Operation mode
0 YES Though a communication trouble occurs between the
host computer and the MODEM (machine side), there is
no effect on the machine operations.
1 NO When a communication trouble occurs between the host
computer and the MODEM (machine side), the self diag
display (U7-00) is displayed and printing is inhibited.
SIMULATION 26-52
BLANK PAPER COUNT UP SETTING. SELECT 0-1, AND PRESS
START.
0. NO (NO COUNT UP)
1. YES (COUNT UP)
1
SIMULATION 26-68
CA KEY CANCEL MODE SETTING. SELECT 0-1, AND PRESS
START.
0. DISABLE
1. ENABLE (PRINT STOP)
0
SIMULATION 27-1
DISABLING OF U7-00 TROUBLE. SELECT 0-1, AND PRESS START.
0. YES
1. NO
1
27-5
Purpose Setting
Function
(Purpose)
Used to enter the machine tag No. (This function
allows to check the tag No. of the machine with the
host computer.)
Section Communication unit (TEL/LIU/MODEM etc.)
Item Specifications Operation mode
30
30-1
Purpose Operation test/Check
Function
(Purpose)
Used to check the operation of sensors and detectors
in other than the paper feed section and the operations
of the related circuits.
Section
Item Operation
PFD2 ADU paper feed detection 2
PPD Resist roller front paper detection
PSD Drum rear paper detection
POD1 After-fusing transport detection 1
POD2 After-fusing transport detection 2
POD3 Paper full detection
DSW_R Manual feed door open detection
DSW_L Cabinet open detection
DSW_F Front cabinet open detection
DSW_DSK Desk door open detection
TFSD Toner remaining quantity detection (Motor rotation
number count)
THPS2 Transfer belt separation home sensor 2
LPPD LCC paper transport detection
T1PPD Tandem tray 1 paper transport sensor
SIMULATION 27-5
TAG # SETTING. INPUT VALUE, AND PRESS START.
PRESENT: 00010000
NEW: 00009999
SIMULATION 30-1
SENSOR CHECK..
PFD2 PPD PSD POD1 POD2
POD3 DSW_R DSW_L DSW_F
DSW_DSK TFSD THPS2 LPPD T1PPD
To Next Page
Loading...
