: Feb. 9 2004
1
AR-M550/M620/M700 SIMULATION 8 - 76
Operation/Procedure
1) Select 2 with 10-key.
2) Press [START] key.
3) Enter the adjustment value with 10key. (1 count: 0.1mm)
4) Press [START] key.
Operation/Procedure
This simulation is used to change and check the engine soft SW. Set
this setting to the default.
There is no need to change this setting in the market.
Operation/Procedure
This simulation is used to change and check the scanner soft SW. Set
this setting to the default.
There is no need to change this setting in the market.
Operation/Procedure
This simulation is used to change and check the controller soft SW. Set
this setting to the default.
There is no need to change this setting in the market.
Operation/Procedure
1) Select the number corresponding to the data transfer mode with
10-key.
53-8
Purpose Adjustment
Function
(Purpose)
Used to adjust the document scan start position. (Used
to adjust the scanner scan position in the SPF mode
front scan.)
Section
Item
Item
Set
range
Default
2 MANUAL Manual feed adjustment (Direct
entry of a number)
1 - 70 32
Select 2, and
press [START] key.
Press [START] key, or
press [CUSTOM SETTINGS] key.
55
55-1
Purpose Setting
Function
(Purpose)
Used to set the specifications of the engine control
operations. (PCU PWB)
Section
Item Operation Specifications
Press [START] key. Press [CUSTOM SETTINGS] key or [START] key.
1
SIMULATION 53-8
SPF SCANNING POSITION ADJUSTMENT. PRESS START.
2.MANUAL 25
1
25
SIMULATION 53-8
SPF SCANNING POSITION ADJUSTMENT. INPUT VALUE 1-70, AND
PRESS START.
2.MANUAL
1
SIMULATION 55-1
ENGINNE SOFT SW. SETTING. SELECT 1-16, AND PRESS START.
12345678
00001001
SIMULATION 55-1
ENGINNE SOFT SW. SETTING. INPUT DATA No(1-8), AND PRESS
START.
SOFT SW-1:
55-2
Purpose Setting
Function
(Purpose)
Used to set the specifications of the scanner control
operations. (Scanner control PWB)
Section
Item Operation Specifications
Press [START] key. Press [CUSTOM SETTINGS] key or [START] key.
55-3
Purpose Setting
Function
(Purpose)
Used to set the specifications of the controller
operations. (MFP control PWB)
Section
Item Operation Specifications
Press [START] key. Press [CUSTOM SETTINGS] key or [START] key.
56
56-1
Purpose Data transfer
Function
(Purpose)
Used to transfer the MFP controller data. (Used to
repair the PWB.)
Section MFP controller
Item Data transfer
1
SIMULATION 55-2
SCANNER SOFT SW. SETTING. SELECT 1-16, AND PRESS START.
12345678
00001001
SIMULATION 55-2
SCANNER SOFT SW. SETTING. INPUT DATA No(1-8), AND PRESS
START.
SOFT SW-1:
1
SIMULATION 55-3
MFP SOFT SW. SETTING. SELECT 1-16, AND PRESS START.
12345678
00001001
SIMULATION 55-3
MFP SOFT SW. SETTING. INPUT DATA No(1-8), AND PRESS
START.
SOFT SW-1:
To Next Page
Loading...
