Sharp AR-M550N - Page 338

AR-M550/M620/M700 SIMULATION 8 - 80
2) Press [START] key.
During the self diag operation, "EXECUTING" is displayed.
If the self diag is completed normally, "0" is displayed. If not, any value
but 0 is displayed.
* = SHORT SELF-TEST, EXTENDED SELF-TEST
Operation/Procedure
1) Enter 1 with 10-key.
2) Press [START] key.
The result of the hard disk operation check (the self diag operation of
the SMART function) is printed out.
Operation/Procedure
1) Select YES/NO of hard disk (the system area excluded) format.
2) Press [START] key.
During formatting, "EXECUTING" is displayed. When formatting is
completed normally, "OK" is displayed. If not, "NG" is displayed.
Operation/Procedure
1) Select YES/NO of deleting the job complete list.
2) Press [START] key.
During formatting, "EXECUTING" is displayed. When formatting is
completed normally, "OK" is displayed. If not, "NG" is displayed.
NOTE: When executed, this function also deletes the complete queues
of E-MAIL, FAX and IFAX, reservation data associated with the
image send function, bulletin board data, and confidential data.
Completion Press [CUSTOM SETTINGS] key.
62-7
Purpose Operation test/Check
Function
(Purpose)
Used to check the operations of the hard disk. (The
result of the self diag operation of the SMART function
is printed out.)
Section MFP controller (HDD)
Item Clear
0 TRAY SELECT Tray select auto only (Selection inhibited)
1 PRINT START Print start
Select 1 and
press [START] key.
Press [CUSTOM SETTINGS] key
or [START] key.
62-8
Purpose Data clear
Function
(Purpose)
Used to format the hard disk (the system area
excluded).
Section MFP controller (HDD)
Item Clear
SIMULATION 62-6
SMART OFFLINE TEST.
1. SHORT SELF-TEST
2. EXTENDED SELF-TEST
1
SIMULATION 62-6
*. EXECUTING···.
Press [START] key.
SIMULATION 62-6
*. COMPLETE.. (result: 0)
SIMULATION 62-7
SMART ERROR LOG PRINT OUT. SELECT SETTING, AND PRESS
START.
0. TRAY SELECT :AUTO ONLY
1. PRINT START
1
0
SIMULATION 62-7
SMART ERROR LOG PRINT OUT. EXECUTING···
0. TRAY SELECT :1
1 YES Execution
2 NO Cancel
Completion Press [CUSTOM SETTINGS] key.
62-10
Purpose Data clear
Function
(Purpose)
Used to delete a job complete list (also to delete job
log data)
Section MFP controller (HDD)
Item Clear
1 YES Execution
2 NO Cancel
Completion Press [CUSTOM SETTINGS] key.
SIMULATION 62-8
HDD FORMAT (EXCEPT SYSTEM AREA).
ARE YOU SURE?
1.YES
2.NO
1
SIMULATION 62-8
HDD FORMAT (EXCEPT SYSTEM AREA). EXECUTING···.
Press [START] key.
SIMULATION 62-8
HDD FORMAT (EXCEPT SYSTEM AREA).. OK. (or NG)
SIMULATION 62-10
JOB COMPLETE DATA CLEAR. (WITH JOB LOG DATA)
ARE YOU SURE?
1.YES
2.NO
1
SIMULATION 62-10
JOB COMPLETE DATA CLEAR. (WITH JOB LOG DATA)
EXECUTING···.
Press [START] key.
SIMULATION 62-10
JOB COMPLETE DATA CLEAR. (WITH JOB LOG DATA)
OK. (or NG)