17
GB
Playing Dolby Digital (5.1 channel), DTS or MPEG audio
Connecting an amplifier with a Dolby Digital/DTS/MPEG Audio digital surround processor or a Dolby Digital/
DTS/MPEG Audio surround processor to your Unit’s coaxial digital jack provides richer and more powerful
audio play.
• This connection is not possible if the processor or amplifier to which you want to connect does not have a coaxial
digital input jack.
■ Connection to a processor or amplifier with a coaxial digital input jack
DIGITAL IN
COAXIAL
S-VIDEO
COMPONENT
COMPONENT
S-VIDEO
OUTPUT
SELECTOR
DIGITAL
AUDIO
LINE OUT 2
DVD
AUDIO
L
R
C
R
C
B
Y
VIDEO
DVD/VCR
LINE OUT 1
LINE IN 1
VCR
AUDIO
L
R
ANTENNA IN
RF OUT
VIDEO
AUDIO
L
R
Required cable
Coaxial digital cable (commercially available)
To coaxial
DIGITAL OUT jack
To coaxial
digital input jack
Coaxial digital cable
(commercially available)
You can make this connection
using a coaxial digital cable.
This Unit
Audio equipment
DVD Audio Connections
Digital Connection to an MD to Record a CD
Some Audio CDs and VIDEO CDs have a short silent section between musical tracks. When sound from discs
such as these is digitally recorded by connecting the Unit directly to a digital recorder (such as an MD player), the
music may be recorded continuously and track numbers may be lost.
■ Digital Connection to Audio Equipment or MD Player without a Dolby Digital Decoder
• Audio CD or VIDEO CD
Play the disc as you normally would, with the audio mode set to “L+R” (see page 89). With a digital
connection, audio of a disc recorded with DTS sounds abnormal in this case.
• DVD
With a digital connection, audio cannot be produced from a DVD recorded with Dolby Digital (5.1 channel),
Dolby Surround (Pro Logic), DTS or MPEG Audio, so you should use an analogue connection to play such
discs. Discs with linear PCM audio should play normally.
DVNC60W(E)#014_020.pm6 01.10.11, 6:34 pm17
Downloaded from: http://www.usersmanualguide.com/
To Next Page
Loading...
