EasyManua.ls Logo

Sharp DV-NC60W - Setting the MPEG

Sharp DV-NC60W
109 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
DVD Setup
47
GB
/
PLAY
STOP
OPEN/
CLOSE
OPERATE
VCR/DVD
SELECTOR
VCR MENU
DVD SETUP
TAPE
SPEED
ON
SCREEN
TIMER
ON/OFF
TITLE
DVD MENU
DISPLAY
G-CODE
EJECT
FUNCTION
CONTROL
PROG/
REPEAT
ZOOM
CLEAR
RETURN
REV FWD
SET
ENTER
ZERO BACK
SKIP SEARCH
TV/VCR
VCR DVDAM/PM
INPUT SELECT
PAUSE/STILL
REC
VCR/DVD COMBINATION
SLOW
CH
VCR DVD
SKIP
DPSS
AUDIO
OUTPUT
3 Use ' or " to select BITSTREAM or D-PCM”.
BITSTREAM: Use this setting for a digital connection of a
receiver (amplifier) equipped with a Dolby Digital
decoder.
D-PCM: Use this setting for a digital connection to the
(Down Mix PCM) PCM digital input jack of a DAT or MD, or for a
digital connection to a receiver (amplifier) that
does not have a Dolby Digital decoder.
4 Press ENTER to confirm the setting.
5 Press RETURN to exit the SETUP screen and return to normal
screen.
When you have completed the above setting, press RETURN
to exit the SETUP screen. However, if you want to specify the
MPEG setting in succession, proceed to step 1 below.
Setting the MPEG
Before setting the “MPEG”, perform the step 1 to 2 on pages 45 and 46.
1 Press ENTER and then use ' or " to select MPEG”.
2 Press ENTER to display the settings you can select.
AUDIO SETUP
COMPRESSION: ON
MPEG:
PCM
BITSTREAM
BITSTREAM
BITSTREAM
DIGITAL:
3 Use ' or " to select BITSTREAM or PCM”.
BITSTREAM: Use this setting for a digital connection of a
receiver (amplifier) equipped with an MPEG Audio
decoder.
PCM: Use this setting for a digital connection to the
PCM digital input jack of a DAT or MD, or for a
digital connection to a receiver (amplifier) that
does not have an MPEG Audio decoder.
4 Press ENTER to confirm the setting.
5 Press RETURN to exit the SETUP screen and return to normal
screen.
If you want to go on and specify other settings, use ' or " to
display the other SETUP screen without pressing RETURN.
When playing a disc recorded using DTS, the bitstream type
signal is output regardless of the setting of “ DIGITAL and
MPEG”.
DVNC60W(E)#039_047.pm6 01.10.11, 9:25 am47
Downloaded from: http://www.usersmanualguide.com/

Table of Contents

Related product manuals