Sharp DV-NC60W

57
GB
Playback
AUTO RENTAL
(This function only works when AUTO RENTAL mode on the MODE
selection screen is set to “ON”.)
The convenient auto rental mode lets you enjoy playback with ease.
When you insert a cassette with the erasure protection tab removed
(rental videos, etc.), your Unit automatically turns on the power,
rewind the tape forward to find the recorded section, and plays back
the tape. When the tape reaches the end of recorded section, the
Unit automatically rewinds the tape, ejects it and turns off the power.
1 Press VCR MENU to display the menu screen.
2 Press ' / " to select “MODE”.
3 Press SET to confirm.
4 Press ' / " to select “AUTO RENTAL”.
AUTO RENTAL ON OFF
COLOUR
REPEAT ON OFF
AUTO PAL MESECAM NTSC
NTSC
3.58 4.43 PAL TV
BLUE BACK AUTO OFF
NICAM AUTO OFF
S.PICTURE ON OFF
:SELECT :CHANGE
SET:ENTER MENU:EXIT
5 Press
\\
\\
\ /
||
||
| to select “ON” or “OFF”.
6 Press SET to confirm and then press VCR MENU to return to
the normal screen.
• If there is more than a 15 second unrecorded section between
recorded sections, the tape will automatically stop and rewind. To
watch the next recorded section, press ËSTOP, fast forward to that
section and play the tape.
• If the erasure protection hole is covered, press ûPLAY after the
power turns on automatically. (AUTO RENTAL Mode does not work.)
• The AUTO REPEAT mode has priority over the AUTO RENTAL mode. If
the AUTO REPEAT mode is set to “ON” and the video cassette
reaches its end, the Unit will rewind the tape and play it back again
without ejecting the tape or turning off the power.
COLOUR
If the quality of a colour recording is poor, the picture may turn black
and white. In this event, set the COLOUR mode on the MODE
selection screen to PAL (fixed PAL colour mode), MESECAM (fixed
MESECAM colour mode), NTSC (fixed NTSC mode). Normally, the
colour mode should be set to “AUTO” mode. (See “Mode Selection”
on page 23.)
1 Follow steps 1 to 3 from “AUTO RENTAL” above.
/
PLAY
STOP
OPEN/
CLOSE
OPERATE
VCR/DVD
SELECTOR
VCR MENU
DVD SETUP
TAPE
SPEED
ON
SCREEN
TIMER
ON/OFF
TITLE
DVD MENU
DISPLAY
G-CODE
EJECT
FUNCTION
CONTROL
PROG/
REPEAT
ZOOM
CLEAR
RETURN
REV FWD
SET
ENTER
ZERO BACK
SKIP SEARCH
TV/VCR
VCR DVDAM/PM
INPUT SELECT
PAUSE/STILL
REC
VCR/DVD COMBINATION
SLOW
CH
VCR DVD
SKIP
DPSS
AUDIO
OUTPUT
DVNC60W(E)#054_063.pm6 01.10.11, 9:29 am57
Downloaded from: http://www.usersmanualguide.com/