Sharp DV-NC60W

73
GB
Confirming Timer Programmes
You can see on the On Screen Display a list of all timer programmes
that are already set.
Preparation
• Press OPERATE. Then move the VCR/DVD CHANGE Switch to
VCR and select the video channel on the TV.
1 Press VCR MENU. (If the “
” indicator on the VCR Front Panel
display is lit, cancel the timer standby mode with TIMER ON/OFF
and then turn on the power.)
2 Select “TIMER” with ' / " and then press SET to confirm .
MODE
MENU
SET:ENTER MENU:EXIT
CHANNEL PRESET
:SELECT
CLOCK
LANGUAGE
TIMER
G-CODE
3 The screen for confirming programmes that have been set will
appear.
DATE PR START STOP
--/-- -- -:-- -:-- --
--/-- -- -:-- -:-- --
--/-- -- -:-- -:-- --
1/2
2/2
15/12 47 12:00 12:30 SP
PMPM
:SELECT
SET:ENTER MENU:EXIT
• Check the information displayed.
• If you want to correct the data, select the programme to be
changed with ' / " and press SET. Correct the setting as
described on pages 70, 71 and 72.
• After the data is changed, press SET at the applicable tape-speed
position at right.
4 Press VCR MENU to return to the normal screen.
• After checking or correcting the programme contents, press
TIMER ON/OFF to enter the Timer Standby mode.
Recording with the Timer
/
PLAY
STOP
OPEN/
CLOSE
OPERATE
VCR/DVD
SELECTOR
VCR MENU
DVD SETUP
TAPE
SPEED
ON
SCREEN
TIMER
ON/OFF
TITLE
DVD MENU
DISPLAY
G-CODE
EJECT
FUNCTION
CONTROL
PROG/
REPEAT
ZOOM
CLEAR
RETURN
REV FWD
SET
ENTER
ZERO BACK
SKIP SEARCH
TV/VCR
VCR DVDAM/PM
INPUT SELECT
PAUSE/STILL
REC
VCR/DVD COMBINATION
SLOW
CH
VCR DVD
SKIP
DPSS
AUDIO
OUTPUT
DVNC60W(E)#064_076.pm6 01.10.11, 9:31 am73
Downloaded from: http://www.usersmanualguide.com/