GB
58
/
PLAY
STOP
OPEN/
CLOSE
OPERATE
VCR/DVD
SELECTOR
VCR MENU
DVD SETUP
TAPE
SPEED
ON
SCREEN
TIMER
ON/OFF
TITLE
DVD MENU
DISPLAY
G-CODE
EJECT
FUNCTION
CONTROL
PROG/
REPEAT
ZOOM
CLEAR
RETURN
REV FWD
SET
ENTER
ZERO BACK
SKIP SEARCH
TV/VCR
VCR DVDAM/PM
INPUT SELECT
PAUSE/STILL
REC
VCR/DVD COMBINATION
SLOW
CH
VCR DVD
SKIP
DPSS
AUDIO
OUTPUT
Playback
2 Press ' / " to select “COLOUR”.
AUTO RENTAL ON OFF
COLOUR
REPEAT ON OFF
AUTO PAL MESECAM NTSC
NTSC
3.58 4.43 PAL TV
BLUE BACK AUTO OFF
NICAM AUTO OFF
S.PICTURE ON OFF
:SELECT :CHANGE
SET:ENTER MENU:EXIT
3 Press
\\
\\
\ /
||
||
| to select “AUTO”, “PA L”, “MESECAM” or “NTSC”.
4 Press SET to confirm and then press VCR MENU to return to
the normal screen.
• When the colour mode is set to fixed colour mode while the Unit is
playing back a black and white tape or is receiving a black and white
broadcast, the picture may be coloured. In this event, set the
COLOUR mode on the MODE selection screen to “AUTO” mode.
BLUE BACK
This function eliminates monitor noise and mutes sound during
playback of unrecorded portions of a tape, and when receiving a
non-broadcasting channel. A blue screen will also appear if the Unit
is set to the Auxiliary input (LINE IN) mode but no video signal is fed
to the Unit. (The BLUE BACK mode is set to “AUTO” at the factory.)
1 Follow steps 1 to 3 from “AUTO RENTAL” on page 57.
2 Press ' / " to select “BLUE BACK”.
AUTO RENTAL ON OFF
COLOUR
REPEAT ON OFF
AUTO PAL MESECAM NTSC
NTSC
3.58 4.43 PAL TV
BLUE BACK AUTO OFF
NICAM AUTO OFF
S.PICTURE ON OFF
:SELECT :CHANGE
SET:ENTER MENU:EXIT
3 Press
\\
\\
\ /
||
||
| to select “AUTO” or “OFF”.
4 Press SET to confirm and then press VCR MENU to return to
the normal screen.
• Blue Back does not function during still picture, variable slow motion
and video search.
• Blue Back may not function properly if the broadcast signal is too
strong or too weak.
• Blue Back cannot be recorded.
• If the antenna signal is weak while recording a TV programme, or if the
input signal is weak while tape dubbing, the monitor screen may turn
blue since the unit may not recognize whether or not a proper signal is
being received. In this event, set the BLUE BACK mode to “OFF”.
DVNC60W(E)#054_063.pm6 01.10.11, 9:29 am58
Downloaded from: http://www.usersmanualguide.com/
To Next Page
Loading...
