DVD Setup
45
GB
AUDIO Setting
COMPRESSION ............ Use this setting for increasing the average
volume of Dolby Digital audio when playing a
DVD.
DIGITAL/MPEG ...... Use these settings for specifying the type of
digital output when playing a disc recorded
using Dolby Digital/MPEG AUDIO.
Setting the COMPRESSION
(Dolby Digital output level)
When Dolby Digital is used to record the audio on a DVD disc, the
average overall volume level of the audio is relatively lower than that
produced by a VIDEO CD/Audio CD. This is to provide the widest
possible dynamic range. To counteract this, this Unit automatically
raises the overall average volume level of a disc recorded using Dolby
Digital to a level that is similar to that of a VIDEO CD/Audio CD.
• OFF .............. Audio level recorded on disc is played back without
modification.
• ON ............... Dolby Digital average audio level is increased so it
sounds similar to that of VIDEO CD/Audio CD.
• Use of the “OFF” setting is recommended when the Unit is connected
to audio equipment or, depending on the disc, the sound is abnormal.
• VIRTUAL DOLBY (QSURROUND) is disabled when “COMPRESSION”
is set to “ON”.
Preparation
• Press OPERATE. Then move the VCR/DVD CHANGE Switch to
DVD.
1 Press DVD SETUP to display the SETUP screen.
DVD
Dolby Digital audio
COMPRESSION:
OFF
COMPRESSION:
ON
• Low audio level
VIDEO CDs
Audio CDs
•
Audio level the same
as audio CD, etc.
/
PLAY
STOP
OPEN/
CLOSE
OPERATE
VCR/DVD
SELECTOR
VCR MENU
DVD SETUP
TAPE
SPEED
ON
SCREEN
TIMER
ON/OFF
TITLE
DVD MENU
DISPLAY
G-CODE
EJECT
FUNCTION
CONTROL
PROG/
REPEAT
ZOOM
CLEAR
RETURN
REV FWD
SET
ENTER
ZERO BACK
SKIP SEARCH
TV/VCR
VCR DVDAM/PM
INPUT SELECT
PAUSE/STILL
REC
VCR/DVD COMBINATION
SLOW
CH
VCR DVD
SKIP
DPSS
AUDIO
OUTPUT
DVNC60W(E)#039_047.pm6 01.10.11, 9:25 am45
Downloaded from: http://www.usersmanualguide.com/
To Next Page
Loading...
