GB
18
To view the output of your Unit on the television screen, you must
select an unused channel on your TV and tune it to the output of your
Unit (see Table 1 for factory preset to UHF Channel).
1 Make sure both units (TV and this Unit) are connected (power
cord) to the power outlet.
2 Turn on your TV.
3 Select an unused channel on your TV.
4 Set the power on the Unit to off. (If the Unit is ON, press
OPERATE to turn off the power.)
5 Keep pressing VCR MENU for more than two seconds to light
up the UHF Channel (see Table 1) on the VCR Front Panel
display.
6 Adjust the tuning of the selected TV channel until the RF pattern
appears on your TV screen. (Refer to your Operation Manual for
tuning procedures.)
RF
SYSTEM I B/G D/K
(RF pattern)
Adjusting the Video Channel
/
PLAY
STOP
OPEN/
CLOSE
OPERATE
VCR/DVD
SELECTOR
VCR MENU
DVD SETUP
TAPE
SPEED
ON
SCREEN
TIMER
ON/OFF
TITLE
DVD MENU
DISPLAY
G-CODE
EJECT
FUNCTION
CONTROL
PROG/
REPEAT
ZOOM
CLEAR
RETURN
REV FWD
SET
ENTER
ZERO BACK
SKIP SEARCH
TV/VCR
VCR DVDAM/PM
INPUT SELECT
PAUSE/STILL
REC
VCR/DVD COMBINATION
SLOW
CH
VCR DVD
SKIP
DPSS
AUDIO
OUTPUT
Factory Preset UHF Channel
60
South East Asia,
Hong Kong
Ex.
Table 1
DVNC60W(E)#014_020.pm6 01.10.11, 9:19 am18
Downloaded from: http://www.usersmanualguide.com/
To Next Page
Loading...
