GB
68
Programming the Timer with G-CODE System
/
PLAY
STOP
OPEN/
CLOSE
OPERATE
VCR/DVD
SELECTOR
VCR MENU
DVD SETUP
TAPE
SPEED
ON
SCREEN
TIMER
ON/OFF
TITLE
DVD MENU
DISPLAY
G-CODE
EJECT
FUNCTION
CONTROL
PROG/
REPEAT
ZOOM
CLEAR
RETURN
REV FWD
SET
ENTER
ZERO BACK
SKIP SEARCH
TV/VCR
VCR DVDAM/PM
INPUT SELECT
PAUSE/STILL
REC
VCR/DVD COMBINATION
SLOW
CH
VCR DVD
SKIP
DPSS
AUDIO
OUTPUT
4 If you are going to record a programme from a station which
does not have the PR number programmed, (“
--
” is displayed)
set that number to be the same as the PR number to which your
broadcasting channel is set into. (See Note on page 69.) Use
the number buttons (0 to 9) or ' / ". Then press
||
||
| .
(Ex.: 47)
DATE PR START STOP
--/-- -- -:-- -:-- --
--/-- -- -:-- -:-- --
--/-- -- -:-- -:-- --
1/2
15/12 47 12:00 12:30 SP
PMPM
:SELECT :CHANGE
SET:ENTER MENU:EXIT
PR :PRESET CH
5 Select the tape speed with ' / ".
DATE PR START STOP
--/-- -- -:-- -:-- --
--/-- -- -:-- -:-- --
--/-- -- -:-- -:-- --
1/2
15/12 47 12:00 12:30 SP
PMPM
:SELECT :CHANGE
SET:ENTER MENU:EXIT
SP/LP.EP:TAPE SPEED
• If the COLOUR mode is set to “AUTO” or “MESECAM”, when a
SECAM signal is received and the EP mode is selected, the Unit will
automatically charge the EP mode to LP mode.
• A tape recorded in the PAL EP (Extended Play) mode can only be
playback in a VCR which have its same function (PAL EP (Extended
Play) mode).
• For best result, it is advisable to Playback or Recording EP mode with
this Unit.
6 Press SET.
ONCE WEEKLY DAILY
G-CODE NO.
-
:SELECT
SET:ENTER MENU:EXIT
• To programme additional timer settings, press SET and repeat steps 2
and 6.
DVNC60W(E)#064_076.pm6 01.11.29, 9:51 AM68
Downloaded from: http://www.usersmanualguide.com/
To Next Page
Loading...
