4-11
FACSIMILEâ–ºBASIC TRANSMISSION METHODS
Entering a pause
If a pause is necessary when dialing an international number, press the [PAUSE] key. (This key functions as a [PAUSE]
key when entering a number.)
If you press the [PAUSE] key once, a hyphen ("-") appears and a 2-second pause* is inserted.
After entering a number, you can also press the [PAUSE] key to enter a hyphen and then enter another number using
the numeric keys. (This connects the numbers together, and is called Chain dialing.)
* The duration of each pause can be changed in the system settings. (See Pause Time (page 7-19)
.)
7
When the reenter screen appears, reenter the fax number.
â–º ADDRESS REVIEW FUNCTION (page 4-7)
8
Press the [OK] key.
9
Press the [START] key.
Scanning begins.
10
If you have another page to scan, change pages and then press the [START]
key.
• Repeat this sequence until all pages have been scanned.
• You can change the resolution and exposure settings as needed for each.
11
After the last page is scanned, press the [READ-END] key ().
Open the document feeder and remove the original. When the original is removed or any key operation is performed, the
display returns to the base screen.
The destination is automatically called and the document transmitted after any previously stored jobs are completed.
To cancel transmission
To cancel transmission while "Reading" appears or before the [READ-END] key ( ) is pressed, press the [C] or [CA]
key. To cancel a transmission job that is already stored, press the [FAX STATUS] key and cancel the job as explained
on (â–ºpage 4-21)
.
• A job number (3 digits) appears in the display with "Read End" when memory transmission is performed.
If you make a note of this number after performing a broadcast transmission, you can use the number to check the
results of the transmission in the transaction report or activity report.
• If the power is turned off or a power failure occurs while an original is being scanned in the document feeder, the
machine will stop and an original misfeed will occur. After power is restored, remove the original as explained in
MISFEED IN THE DOCUMENT FEEDER (page 6-14)
.
Group dials cannot be used for chain dialing.
To Next Page
Loading...
Need help?
General
