4-10
FACSIMILEâ–ºBASIC TRANSMISSION METHODS
Using the document glass
1
Make sure that the machine is in fax
mode.
The FAX indicator is lit when the machine is in fax mode. If
the indicator is not lit, press the [FAX] key.
If user authentication has been enabled for the fax function
in the system settings, a message will appear prompting you
to enter your user number when you switch to fax mode.
Enter your account number (5 digits) with the numeric keys.
â–º User Authentication (page 7-12)
2
Place the original.
Place the original on the document glass.
â–º DOCUMENT GLASS (page 1-32)
This is a single transmission operation, and therefore originals cannot be scanned in succession from both the
document feeder and the document glass.
3
Specify the original size.
Select the "Original Size" on the right menu.
The paper size that can be selected is 8-1/2" x 11",
8-1/2" x 14" or A4.
4
If needed, adjust the resolution and exposure settings.
5
Dial the fax number.
• The entered number appears in the message display. Up to 50 digits can be entered. If you make a mistake, press the
[C] key and then enter the correct number.
• Redialing and automatic dialing can also be used (►page 4-6
, â–ºpage 4-12).
• To enter a pause, see Entering a pause (page 4-11).
6
Press the [OK] key.
To Next Page
Loading...
Need help?
General
