Sharp MX-M620N

MX-M700N SIMULATION 7 – 58
62
62-1
Purpose
Data clear
Function (Purpose)
Used to format the hard disk.
Section
MFP controller (HDD)
Operation/Procedure
1) Select YES/NO of hard disk format.
2) Press the [START] key.
During formatting, "EXECUTING" is displayed. When formatting is
completed normally, "OK" is displayed. If not, "NG" is displayed.
62-2
Purpose
Operation test/Check
Function (Purpose)
Used to check the operation of the hard
disk (read/write). (Only in the model with a
disk installed) (Partial check)
Section
MFP controller (HDD)
Operation/Procedure
1) Select YES/NO of hard disk read/write check.
2) Press the [START] key.
During testing, "EXECUTING" is displayed. When test is completed
normally, "OK" is displayed. If not, "NG" is displayed.
62-3
Purpose
Operation test/Check
Function (Purpose)
Used to check the operation of the hard
disk (read/write). (All areas check)
Section
MFP controller (HDD)
Operation/Procedure
1) Select YES/NO of hard disk read/write check.
2) Press the [START] key.
During testing, "EXECUTING" is displayed. When test is completed
normally, "OK" is displayed. If not, "NG" is displayed.
62-6
Purpose
Operation test/Check
Function (Purpose)
Used to check the operations of the hard
disk. (The self diag operation of the SMART
function is executed.)
Section
MFP controller (HDD)
Operation/Procedure
1) Select the number corresponding to the self diag check mode.
2) Press the [START] key.
During the self diag operation, "EXECUTING" is displayed. If the
self diag is completed normally, "0" is displayed. If not, any value
but 0 is displayed.
62-7
Purpose
Operation test/Check
Function (Purpose)
Used to check the operations of the hard
disk. (The result of the self diag operation
of the SMART function is printed out.)
Section
MFP controller (HDD)
Operation/Procedure
1) Enter 1 with 10-key.
2) Press the [START] key.
The result of the hard disk operation check (the self diag operation
of the SMART function) is printed out.
1YES Execution
2NO Cancel
1YES Execution
2NO Cancel
1YES Execution
2NO Cancel
SIMULATION 62-1
HDD FORMAT.
ARE YOU SURE?
1. YES
2. NO
1
SIMULATION 62-2
HDD R/W TEST.
ARE YOU SURE?
1. YES
2. NO
1
1 SHORT SELF-TEST Partial test
2 EXTENDED SELF-
TEST
All areas test
0 TRAY SELECT TRAY SELECT auto only (Selection is not
allowed.)
1 PRINT START PRINT START
SIMULATION 62-3
HDD R/W TEST(ALL).
ARE YOU SURE?
1. YES
2. NO
1
SIMULATION 62-6
SMART OFFLINE TEST.
1. SHORT SELF-TEST
2. EXTENDED SELF-TEST
1
㩷㩷㩷㩷
䋴
SIMULATION 62-7
SMART ERROR LOG PRINT OUT. SELECT SETTING, AND PRESS
START.
0. TRAY SELECT :AUTO ONLY
1. PRINT START
1