Sharp MX-M620N

MX-M700N DSPF SECTION C – 8
2) Remove the mat.
[Caution when attaching]
• Place the mat on the document base glass surface; close the
DSPF to attach the mat; then open again and apply pressure by
hand to attach.
B. The paper feed tray section
(1) The document tray section
1) Remove the cabinet. (See “A-(1)-a. Cabinet”)
2) Disconnect the connector, and remove the document tray unit.
a. DSPF document length detector 1
b. DSPF document length detector 2
c. DSPF document size (Width) detection analog data
detector
1) Remove the cabinet. (See “A-(1)-a. Cabinet”)
2) Remove the document tray unit.
(See “B-(1) Document tray unit”)
3) Remove the screw, and remove the cover.
No. Unit No. Parts
(1) Document tray unit a DSPF document length detector 1
b DSPF document length detector 2
c DSPF document size (Width)
detection analog data detector
(2) Others a DSPF paper tray lift motor
b DSPF paper tray lower limit detector
c DSPF document empty detector
(1)
(1)-a
(1)-b
(1)-c
(2)-a
(2)-b
(2)-c