MX-M700N OTHERS 12 – 15
FSTPL FINISHER saddle staple JAM Start of saddle stapling When the staple HP sensor does not
sense ON within the specified time
from stapler HP sensor OFF in
stapling process, and when the staple
HP sensor detects ON in reverse
rotation after stopping the stapler.
500ms
FPNCH FINISHER punch JAM Punch HP OFF after
starting punching
The punch HP sensor does not turn
ON within the specified time.
200ms
FDOP FINISHER door open JAM One of finisher doors
open
Finisher door open is detected in
finishing process.
---
JAM code Content
JAM detection method
JAM judgment time
(Stacker:
LTR horizontal size
Saddle: LTR vertical size)
JAM detection timer
start trigger
JAM judge detector
Common to 55/62,
70PPM MODELS
(Main unit paper exit speed:
Stacker: 800mm/s
Saddle: 420mm/s)
To Next Page
Loading...
Need help?
General
