Sharp MX-M620N

MX-M700N PHOTOCONDUCTOR SECTION J – 4
3. Disassembly and assembly
A. OPC drum Section
(1) Process unit
1) Open the front door.
2) Open the process cover.
3) Open the left door.
4) Remove the MC charger unit.
5) Remove the blue screw.
6) Unfix the drum to remove the bearing.
7) Pull out the process unit by clasping the bolt head.
No. Unit No. Parts
Mainte
nance
(1) Process unit a OPC drum ✕▲
b Separation pawl ✕▲
c Cleaning blade ✕▲
d Toner reception seal ✕▲
e Side seal F/R ✕▲
f Side seal R base sheet
g Cleaning brush ▲
h Process adsorption plate
i Drum separation pawl
solenoid
j OPC drum cleaner
temperature sensor
k Discharge lamp
l Image density sensor
m OPC drum marking sensor
(1)-a
(1)
(1)-k
(1)-m
(1)-i
(1)-j
(1)-h
(1)-l
(1)-g
(1)-e
(1)-c
(1)-b
(1)-d
(1)-e
(1)-f