Sharp MX-M620N

MX-M700N DEVELOPING SECTION L – 4
7) Remove the side seals F and R.
8) Remove the MG roller unit.
9) Remove the doctor attaching plate.
10) Remove the MG holders F and R.
d. Side seal F and R
1) Take out the developing tank. (See “(1) Developing unit”)
2) Remove the doctor cover.
3) Peel off the right and left side seals.
4) Clean the peeled area.
5) Peel off the new right and left seals from the mounting paper
and affix in the designated positions.
e. Toner density sensor
1) Take out the developing tank. (See “(1) Developing unit”)
2) Remove the DV cover. (See “a. Developer”)
3) Remove the toner concentration sensor.