Sharp MX-M623U User Manual

1-64
BEFORE USING THE MACHINE
Contents
Alarm display
If the [START] key indicator on the inserter operation panel is blinking and the [PUNCH] key or [STAPLE] key indicator
is also blinking or solidly lit, operation will not start when the [START] key is pressed. Resolve the problem as indicated
below, depending how the indicators are lit or blinking.
[PUNCH]
indicator
[STAPLE] indicator
[START]
indicator
Cause Solution
Any one of the indicators is solidly lit. Blinks red
A paper size that cannot be fed
has been loaded.
Use paper that is a suitable size
for punching, stapling, or saddle
stitching (page 1-62).
- - - -
Solidly
lit
Blinks red
The paper type of the inserter is
set to heavy paper.
Heavy paper cannot be used.
Blinking - - - - Blinks red
The finisher or saddle stitch
finisher tray is full.
Remove the paper from the
tray.
The hole punch scrap container
in the punch module on the
finisher or saddle stitch finisher
is full.
Discard the hole punch scrap
(page 1-55).
-
Any one of the
indicators is blinking.
- Blinks red
The finisher or saddle stitch
finisher tray is full.
Remove the paper from the
tray.
The finisher or saddle stitch
finisher is out of staples.
Replace the staple cartridge
(page 1-52).
- - - - Blinking Blinks red
The saddle stitch tray on the
saddle stitch finisher is full.
Remove the paper from the
saddle stitch tray.
The saddle stitch finisher is out
of saddle stitch staples.
Replace the saddle stitch staple
cartridge (page 1-54).

Sharp MX-M623U Specifications

General

Brand	Sharp
Model	MX-M623U
Category	All in One Printer
Language	English