7-36
SYSTEM SETTINGS
*1 When a saddle stitch finisher is installed.
*2 When a finisher is installed.
*3 When a large capacity tray is installed.
*4 When a saddle stitch finisher or finisher is installed.
*5 When an inserter is installed.
*6 When a punch module is installed.
Copy Function Settings
Disabling of Finisher*
4
Disabled 7-72
Disabling of Inserter*
5
Disabled 7-72
Disabling of Offset Disabled 7-72
Disabling of Stapler*
4
Disabled 7-72
Disabling of Punch*
6
Disabled 7-72
● Fusing Control Settings 16 - 23 lbs. (60 - 89g/m
2
) 7-72
Item Factory default setting Page
■ Copy Function Settings
7-73
● Initial Status Settings
7-73
Paper Tray Varies depending on the machine
configuration
Exposure Type Auto
Copy Ratio 100%
2-Sided Copy 1-Side to 1-Side
Output –
● Other Settings 7-74
Copy Exposure Adjustment 5 7-74
Rotation Copy Setting Enabled 7-74
Add or Change Extra Preset Ratios – 7-74
Setting a Maximum Number of Copies 999 7-74
Initial Margin Shift Setting
7-74 Side 1 1/2"
Side 2 1/2"
Erase Width Adjustment
7-74 Edge Clearance Width 1/2"
Center Clearance Width 1/2"
Card Shot Settings
7-74 Original Size X: 3-3/8", Y: 2-1/8"
Fit to Page Disabled
Automatic Saddle Stitch* Enabled 7-74
Initial Tab Copy Setting 1/2" 7-74
Item Factory default setting Page
To Next Page
Loading...
Need help?
General
