Sharp UP-600

166
Secret Code Programming
Use the following procedure to program a secret code:
1. In the SETTING window, select “11 SECRET CODE.”
• The SECRET CODE window will appear.
2. Select any option from the following options list:
1 Z1: Z1 reports
2 PGM2: PGM2 operations
3 SYS Z1: System Z1 reports
4 SYS PGM2: System PGM2 operations
5 INITIAL D/L: Initial down-loading
6 MAINTE. D/L: Maintenance down-loading
The following illustration shows those options included in the secret code programming group.
11 SECRET CODE 1 Z1 See “Z1 reports” on page 167.
2 PGM2 See “PGM2-mode operations” on page 167.
3 SYS Z1 See “System Z1 reports” on page 168.
4 SYS PGM2 See “System PGM2-mode operations” on page 168.
5 INITIAL D/L See “Initial down-loading” on page 169.
6 MAINTE. D/L See “Maintenance down-loading” on page 169.