105
• REPEAT ROUND (Use the selective entry)
YES : Allows repeat round registration
NO : Inhibits repeat round registration
• DATA ENT. JOB# (Use the numeric entry)
Key data entry job number (Capture job number: 0 thru 99)
When “0” is programmed, data entry is inhibited.
• NON-ACCESS (Use the selective entry)
NON DEL.: Not delete non-accessed UPCs by Z1 report.
DEL. BY Z: Delete non-accessed UPCs by Z1 report.
NOTE
For PLU, it is fixed to “NON DEL.”.
Dynamic UPC
NOTE
For the UPC codes available to this POS terminal and type UPC files, please refer to the chapter
14.
After you select “3 DYNAMIC UPC” on the “ARTICLE” menu, enter an UPC code or select a pertinent code.
The same setting items excepting MIN. STOCK as the “PLU/UPC” described in the previous section will
appear. Please refer to “PLU/UPC” section for entering values or selecting options. The data will be saved
in the Dynamic UPC file.
PLU range
You can program the PLUs by a range as follows:
Enter a value or select an option for each item as follows:
• START (Use the numeric entry)
Starting PLU code (max. 5 digits)
• END (Use the numeric entry)
Ending PLU code (max. 5 digits)
• OPERATION (Use the selective entry)
MAINTE.: Enables you to change the setting
you have programmed.
NEW&MAINTE: Enables you to change the current
setting when the specified codes
have already been created or to
create new codes when the
specified codes have not been
created yet.
DELETE: Enables you to delete a specified
range of PLUs.
The screen continues in the same
format as screens shown in section
“
PLU/UPC.”
PLU/UPC (continued)
To Next Page
Loading...
Need help?
General
