6
INSTALLING THE MEMORY
BACKUP BATTERY
The lithium battery is used to back up the calendar
and other memory functions.
I
1
2
3
4
5
6
_
Slide the OPEN release in the direction of the
arrow and open the cassette compartment door.
Holding the LCD monitor side towards you,
rotate the lens section vertical to the monitor
section.
Remove the lithium battery compartment cover in
the direction of the arrow.
Insert the lithium battery firmly into place with the
+ side facing out.
Be sure that the + and
-
poles are correctly
oriented.
Reattach the cover firmly
unttl
it clicks into place
Rotate the lens section and return it to the normal
position
REPLACE BATTERY WITH SHARP TYPE CR2025
(PART NO.
UBATL0004TAZZ)
OR SONY
ENERGYTEC TYPE CR2025 ONLY. USE OF A
DIFFERENT BATTERY MAY PRESENT A RISK OF
FIRE OR EXPLOSION.
B
KEEP THIS BATTERY AWAY FROM
CHILDREN. IF SWALLOWED, CONSULT A
PHYSICIAN IMMEDIATELY FOR EMERGENCY
TREATMENT.
B
BATTERY MAY EXPLODE IF
MISTREATED OR INSTALLED WITH POLARITY
REVERSED DO NOT RECHARGE,
DISASSEMBLE OR DISPOSE OF IN FIRE
Cautions:
l If the
Irthtum
battery is installed
with
polanty reversed, the
VIEWCAM
will not turn on.
. Do not
short-circutt,
recharge, disassemble or heat the
battery
l Should the battery leak,
wrpe
the battery compartment
clean and
Insert
a new battery.
Notes:
l The
lrthrum
battery is used to back up the calendar and
other memory
functtons.
l The battery will last one year of normal usage
l Replace the battery
with
a new CR2025 cell when the
VIEWCAM
time indicator starts to fall behind correct time
INSTALLING THE BATTERY IN
THE REMOTE CONTROL
Open the lid of the battery compartment by
sliding it out with an object such as a slotted
screwdriver.
Install the supplied CR2025 lithium battery with
the + side facing upward.
Replace the lid by sliding it in the direction of the
arrow.
10
To Next Page
Loading...
