AC
adaptor
VI
EWCAM
securing
lever
.
LED lamp window
CHARGING ON THE
VIEWCAMPORT
UNIT
If the
VIEWCAM
is attached to the ViewCamport unit,
the battery pack in the
VIEWCAfy’l
can be charged
automatically and continuously.
The ViewCamport unit keeps your
VIEWCAM
ready
to operate at any time.
Attach the AC adaptor to the ViewCamport unit
and insert the AC plug into a wall outlet.
Insert the battery pack in the
VIEWCAM.
(See
page 14.)
l Make sure that the Operate switch is set to
OFF, otherwise charging is not possible when
the
VIEWCAM
is in the VCR or CAMERA mode
Attach the
VIEWCAM
to the ViewCamport
unit
with the LCD monitor facing the
ViewCamport’s
LED lamp window side.
Slide
the
VIEWCAM
secunng
lever.on
the
ViewCamport unit in the direction of the arrow to
the lock position. Charging starts automatically.
l
The charge indicator will not light up in this case
The
BT-L1
battery will take about
10
hours to
fully charge.
Charging Two Battery Packs
Successively
You can charge two battery packs successively with
the ViewCamport unit.
1
2
Insert the first battery pack in the
VIEWCAM
and
attach the
VIEWCAM
to the ViewCamport unit.
(See above
)
Attach the second battery pack to the AC
adaptor/battery charger as shown at left.
Turn off the
VIEWCAM’s
power.
Removing the
VIEWCAM
from the
ViewCamport Unit
Press the
VIEWCAM
release button and remove the
VIEWCAM.
Note:
If the
VIEWCAM
is
removed from
the ViewCamport unit,
the battery pack inside will naturally discharge
wrth
time,
even after it has been fully charged We recommend you
place the
VIEWCAM
on the ViewCamport unit even when
it is not in use.
Cautions:
l Do not use excessive force with the
VIEWCAM
and/or
ViewCamport unit. Doing so may cause damage or
malfunction.
l Do not move the ViewCamport unit by lifting the
VIEWCAM
while it is still attached to the ViewCamport
unit.
The battery pack on the AC adaptor/battery
charger will be charged first and then the
battery pack in the
VIEWCAM
will be charged.
The charge level of the battery pack in the
VIEWCAM
can be monitored by removing the
VIEWCAM
from the ViewCamport unit and
setting it to Camera or VCR mode.
Note:
Charging the battery pack
In
the
VIEWCAM
on the
ViewCamport
unit
will take longer than charging by the
AC adaptor. If you are
In
a hurry, we recommend you use
the AC adaptor.
Removing the AC Adaptor from the
ViewCamport Unit
Press the AC adaptor release button and pull out the
adaptor.
To Next Page
Loading...
