INSERTING AND REMOVING
THE BATTERY PACK
Inserting
Pull up the battery compartmknt latch on the
bottom of the
VIEWCAM
and turn it counter-
clockwise to open the battery compartment.
Insert the battery pack into the compartment and
push it until it clicks into the notch.
Close the cover and turn the latch clockwise to
secure it firmly.
Removing
Pull up the battery compartment latch on the
bottom of the
VIEWCAM
and turn it counter-
clockwise to open the battery compartment.
Press the notch, tilt the
VIEWCAM
so the opening
faces down and remove the battery pack.
Close the cover and turn the latch firmly
clockwise to secure it.
Battery pack handling
Make sure that you take enough battery packs
with you to provide two to three times your
estimated recording time.
Recording time will be reduced in cold weather
The battery will drain in the Recording Standby
mode. Turn off the power if you will not be
recording again soon.
Cautions:
l Do not expose the battery compartment cover to strong
force, as
it
may come off.
l If you remove the battery pack durrng recording or
playback, the tape will remain wound around the
vrdeo
head drum and may be damaged.
BEFORE REMOVING THE BATTERY PACK, ALWAYS
STOP THE TAPE AND TURN THE POWER OFF
Should the power source (battery or adaptor) become
disconnected during
operatron,
reconnect it again
immediately.
l Remove the battery pack from the
VIEWCAM
or
dtsconnect the
VIEWCAM
from the AC adaptor or
ViewCamport unit
If
the
VIEWCAM
will not be used for a
long time.
. Be sure to close the battery compartment cover firmly,
especially during operations If not, the battery pack may
come off or
VIEWCAM
operation may fail because of the
poor contact pressure.
14
To Next Page
Loading...
