Sharp Viewcam VL-H410X

FULL AUTO button
FULL AUTO
2
FOCUS
W/B SHUT.
L
SPEEP
Recommended Shutter Speeds
The faster the shutter speed, the darker the picture
becomes. You need to select the most appropriate
shutter speed for the ambient light. The selected
shutter speed will be displayed on the monitor.
l Recording sport players in bright daykght
l Recording outdoor sports on a somewhat
cloudy day
l Recordrng outsrde scene through a car .
1 /l 000 sec. or
window, (When you want to minimze blurs
l/250 set
caused by camera shake.)
l When you want to reduce the recerved
light by half Used as replacement of ND2 l/l 20 sec.
falter
Note on recording under fluorescent lighting
When you are recording under fluorescent lighting,
if the monitored picture flickers, you may be able to
normalize this by changing the shutter speed to
l/l20 sec.
HIGH-SPEED SHUTTER
When you want to shoot fast-moving subjects such
as golfers swinging their clubs or tennis players
swinging their rackets, use a high shutter speed.
Playback the recorded scene in $till Picture mode
on the VIEWCAM, or playback a dubbed tape on a
VCR with still picture playback capability - you will
enjoy clear, blur-free, frame-by-frame still pictures.
Press and hold down the FULL AUTO button for
more than 1 second.
l The “FULL AUTO” indicator disappears and
the manual operation indicators appear on the
monitor.
Select the shutter speed by pressing the SHUT.
SPEED button. Check that the desired shutter
speed is displayed on the monitor. You can now
start recording by following the same operating
procedure as usual.
Each time you press the SHUT. SPEED button,
the shutter speed indicator on the monitor
changes in the sequence shown below.
l/50 (Normal) + l/120 + i/250 + l/t000
1 /10000 f- l/4000
Normal mode
High speed shutter mode
The scenes recorded with the electronic high-speed
shutter can be played back in Still Picture mode on
the VIEWCAM or a VCR with still picture capability
You will enjoy seeing much more blur-free pictures,
as compared to those recorded with the normal
shutter speed.
Notes:
l Using fast shutter speeds under fluorescent lighting will
cause flickering in the picture and possibly periodic
colour shifts.
l Recording with shutter speeds higher than l/50 sec.
(standard) tends to darken the picture. Record in bright
locations when you use higher shutter speeds.
l To return to the Full Auto mode, hold down the FULL
AUTO button for more than 1 second until the “FULL
AUTO” indicator appears on the monitor.
42
__