Sharp Viewcam VL-H410X - Still and Strobe Recording

STILL/STROBE RECORDING
You can record still or strobe (still pictures that
capture continuous motion at l/6 sec. intervals)
images of subjects with normal sound.
You will find it useful when you Aant to record a shot
of a tourist information board during sightseeing (Still
recording), or produce a special effect while
recording moving subjects such as your friends
waving at you (Strobe recording).
1 Press the STILL/STROBE button in the Recording
Standby mode:
I, 3
STILL/STROBE button
39
Press the button once to select Still Recording
mode; twice to select Strobe Recording mode.
l Each time you press the button, the recording
mode changes as follows:
r) Normal + Still --) Strobe 1
2
3
Press the REC START/STOP button to start Still
or Strobe recording.
To return to normal recording, press the
STILL/STROBE button twice in the Still recording
mode; once in the Strobe recording mode.
Notes:
l You can swatch between Still Recording mode and Strobe
Recording mode while the VIEWCAM is recording or in
Recording Standby mode.
l Once the Still or Strobe Recording mode is set, unless
they are cancelled, the VIEWCAM continues to record in
those modes even after in the Recording Standby mode.
l The picture quality in those mode will be slightly lower
than normal pictures.
l In the Strobe Recording mode, the shutter speed is
automatically switched from the standard l/50 sec.
speed to l/120 sec.
l In the Still Recording mode, the DIS button does not
function.
Caution:
Do not keep the VIEWCAM in the Still Recording mode
too long. The monitor may hold an afterimage Turn off
the VIEWCAM and wait for a while. The monitor will return
to normal.