USING THE INFRARED
REMOTE CONTROL
192
Approximate operating range
of remote control
USING THE STAND
Pull out the stand and lock it into position when you
put the
VIEWCAM
on a table or other flat surface.
For stability, make sure the
VIEWCAM’s
camera part
stands vertically, as shown.
Cautions:
l Protect the stand from strong forces. Otherwise it may
break.
l
When the stand is not in use,
fold it away to keep it from
breaking by pressing in the
direction of the arrow.
Use the remote control to operate the
VIEWCAM
from a distance, for example w
‘k
en you want to
record yourself in a scene, or w en the VIEWCAM is
connected to a TV for use as a VCR.
Set the Operate switch to CAMERA or VCR.
When CAMERA is selected
Press the MENU button to display MENU 2.
If MENU
1
is displayed, press the PAGE button
(0)
to get MENU 2 on the monitor.
When VCR is selected
Press the MENU button to display the menu.
Make sure that the “REMOTE” menu item is set
to “ON”.
Press the MENU button to turn off the menu.
In the CAMERA mode In the VCR mode
c
MENU 2
’
HiI3
AUTO
:
iEhME;EC
;XA;AfO”“ECT
bREMOTE
l DGTL
y4;;
#TL
ZOOM
v
1
A
ISET
1
IPAGE
I
MENU
:
;,iAT
OFF
,REiOTE
%iTO
c
v
1
A
ISET
I
I
4
Aim the remote control at the photoreceptor of
the
VIEWCAM,
and press the control buttons to
operate the
VIEWCAM.
Notes:
l Be careful not to allow direct sunlight or bright light from
interior
rllumination
to fall onto the
VIEWCAM’s
photoreceptor, as this may prevent the remote control
from operating properly.
l Be sure that there are no obstacles between the remote
control and the
VIEWCAM’s
photoreceptor.
l When the “REMOTE” setting is changed in either Camera
or VCR mode, the setting for the other mode is
automatically set the same.
l The lithium battery normally lasts about 6 months.
This
time can be shorter under some operating conditions.
When the lithium battery is dead and the remote control
does not operate, replace the battery with a new one by
following the instructions on page 10.
l If “OFF” has been selected for “REMOTE” on the menu,
the
VIEWCAM
will not respond to remote control
commands. Select “ON” to make the
VIEWCAM
respond
to the remote control.
36
To Next Page
Loading...
