Sharp Viewcam VL-H410X

15
INSERTING AND REMOVING A
CASSETTE
Inserting a Cassette ,
1
2
3
4
5
Slide the OPEN release to open the cassette
compartment door.
Press the EJECT button.
l The cassette compartment extends
automatically.
Insert the video cassette with the window facing
outward.
l Make sure that the red projection is set to
OPEN and that there is no slack in the tape.
Press the “PUSH” mark until the compartment
clicks into place.
l The cassette compartment retracts
automatically. (Do not force the compartment
to close and avoid catching your fingers as the
compartment closes.) Do not turn the
VIEWCAM power on or off at this time.
Close the compartment door by pressing its
centre until the cover clicks into place.
l Make sure that the cassette compartment has
properly retracted before closing the door.
Removing a Cassette
1
Slide the OPEN release to open the cassette
compartment door.
2 Press the EJECT button to extend the cassette
compartment.
3 Take out the cassette.
4 The cassette compartment retracts, then close
the compartment door.
Cautions:
l Do not try to close the door while the cassette
compartment is being extended or retracted.
l Be careful not to get your fingers caught in the cassette
compartment.
l Do not apply force to the cassette compartment except
when pressing the “PUSH” mark to close it.
l Do not tilt the VIEWCAM or hold it upside-down when a
video cassette is being inserted or removed, this may
damage the video cassette.
l Remove the video cassette if the VIEWCAM will not be
used for a long time.
l If you do not press the cassette compartment closed
correctly in step 4 above, the VIEWCAM’s cassette
protectron mechanism might eject the cassette. Repeat
the Insertion procedure.
l Do not attempt to lift the VIEWCAM by the cassette
compartment door.
To protect recordings from accidental erasure
Slide the red profection on the vrdeo cassette in the
direction of the arrow until the red indicator IS visible
To record on the tape again, slide the red projection in
the reverse directton.