TURNING OFF THE LCD
MONITOR BACKLIGHT
LAMP OFF indicator
MODE DISPLAY button
VIEWCAM’s
LCD monitor uses a fluorescent lamp for
backlighting (see page 51).
,
You can turn off the lamp when backlighting is not
necessary; e.g. when you are watching a playback
picture on a connected TV screen. Turning off the
lamp will reduce power consumption.
In Camera or VCR mode, hold down the MODE
DISPLAY button. Two seconds later, “LCD LAMP
OFF” starts flashing on the monitor. Keep the MODE
DISPLAY button down for 3 more seconds, and the
backlight turns off and the LAMP OFF indicator lights
UP.
To turn on the backlight again, press the MODE
DISPLAY button or set the Operate switch to OFF
and then back to CAMERA or VCR.
Note:
If the LAMP OFF tndlcator starts flashing when the
backlight is turned off, this indicates that the
VIEWCAM
wants to display warning messages.
Press the MODE DISPLAY button to turn the backlight on
and check the warning messages.
30
To Next Page
Loading...
