14
Removed/Excluded
The LED will be blinking blue in Mode 1 for 30 min after every power cycle and 10 min after S
button pressed.
Added/Included
The LED will be blinking green in Mode 1 for 30 min after every power cycle and 10 min after S
button pressed.
Settings in progress
Factory reset and reboot
During factory reset, the LED will turn solid green for approx. 1sec, then the blue and red LED
will be blinking 0,1s On / 0,1s Off for about 2sec.
Adding / Removing
During adding or removing, the LED will be blinking blue in Mode 2.
OTA firmware updating
During the OTA update, the LED will be blinking blue and red in Mode 2.
Checking power supply 230 V AC frequency or 24 V DC voltage
During checking the power supply, the LED will be blinking blue and red in Mode 5.
Settings mode with S button
To Next Page
Loading...
