Need help?Do you have a question about the Sherwood RD-6502 and is the answer not in the manual?
Amplifier Section| power output in stereo mode | 2×100 W |
|---|---|
| total harmonic distortion | 0.09 % |
| intermodulation distortion | 0.1 % |
| input sensitivity | 280 mV |
| signal to noise ratio | 92 dB |
| frequency response | +0 dB, -3 dB |
| output level TAPE REC | 280 mV |
| output level PRE OUT (Subwoofer) | 1.0 V |
| bass/treble control | ±10 dB |
| surround mode front power output | 125 W / 125 W |
| surround mode center power output | 125 W |
| surround mode surround power output | 125 W / 125 W |
Digital Audio Section| sampling frequency | 32, 44.1, 48, 96 kHz |
|---|---|
| digital input level coaxial | 0.5 Vp-p |
| digital input level optical | -15~-21 dBm |
Video Section| video format | PAL |
|---|---|
| input sensitivity (output level) video | 1 Vp-p |
FM Tuner Section| tuning frequency range | 87.5~108 MHz |
|---|---|
| usable sensitivity | 12.8 dBf |
| 46 dB quieting sensitivity mono/stereo | 20.2 / 45.3 dBf |
| signal to noise ratio mono/stereo | 55 / 50 dB |
| total harmonic distortion mono/stereo | 0.5 / 1.0 % |
| frequency response | ±3.0 dB |
| stereo separation | 30 dB |
| capture ratio | 4 dB |
| IF rejection ratio | 80 dB |
AM Tuner Section| tuning frequency range | 522~1611 kHz |
|---|---|
| usable sensitivity | 500 µV/m |
| signal to noise ratio | 40 dB |
| selectivity | 25 dB |
General| power supply | 230 V ~ 50 Hz |
|---|---|
| power consumption | 330 W |
| switched AC outlet | Total 100 W (0.43A) max. |
| dimensions | 440×141×365 mm (17-3/8×5-1/2×14-3/8 inches) |
| weight | 9.5 kg (20.9 lbs) |
To Next Page
