ENGLISH
41
When selecting the DOLBY PLII MUSIC
• You can adjust the various surround parameters for optimum surround effect.
Note:
• The parameter settings are valid only when listening in Dolby Pro Logic II Music mode.
When selecting the "PANO (Panorama)" mode
This mode extends the front stereo image to include the
surround speakers for an exciting "wraparound" effect with
side wall imaging. Select "OFF" or "ON"(default value:OFF).
When selecting the "C. WIDTH (Center width)" control
This adjusts the center image so it may be heard only from
the center speaker, only from the left/right speakers as a
phantom image, or from all three front speakers to varying
degrees. The control can be set in 8 steps from 0 to 7
(default value : 3).
When selecting the "DIMEN (Dimension)" control
This gradually adjusts the soundfield either towards the front
or towards the rear. The control can be set in 7 steps from
-3 to +3 (default value : 0).
1
. Press the CURSOR UP()/DOWN() buttons to select the "PLII MSC", then press the ENTER
button.
2. Press the CURSOR UP()/DOWN() buttons to select the desired parameter.
3
. Press the CURSOR LEFT()/ RIGHT() buttons to adjust the selected parameter as desired.
4. Repeat the above steps 2 and 3 to adjust other parameters.
To Next Page
Loading...
Need help?
Amplifier Section
