- 12 -
Screen Group 5 Initial setting screen group Screen
5-0 Initial screen
5-23 screen
5-1 The number of patterns setting5-23 Event 2 hysteresis setting
5-2 Time unit setting5-24 Event 2 standby action setting
5-3 With/without power failure compensation setting5-25 Event 3 type setting
5-4 Input abnormality mode setting5-26 Event 3 hysteresis setting
5-5 Measuring range code setting5-27 Event 3 standby action setting
5-6 Input unit setting5-28 Status output 1 action code setting
5-7 Input scaling lower limit value setting5-29 Status output 2 action code setting
5-8 Input scaling higher limit value setting 5-30 Status output 3 action code setting
5-9 Input scaling decimal point position setting 5-31 Status output 4 action code setting
5-10 PV Bias setting5-32 Analog output type setting
5-11 PV filter setting5-33 Analog output scaling lower limit setting
5-12 Output control characteristics setting 5-34 Analog output scaling higher limit setting
5-13 Proportional cycle setting 5-35 Communication mode setting
5-14 SV limiter lower limit value setting 5-36 Communication protocol Setting
5-15 SV limiter higher limit value setting 5-37 Communication address setting
5-16 External control input 2 action code setting 5-38 Communication speed setting
5-17 External control input 3 action code setting 5-39 Communication data format setting
5-18 External control input 4 action code setting 5-40 Start character setting
5-19 Event 1 type setting 5-41 BCC operation type setting
5-20 Event 1 hysteresis setting 5-42 Delay time setting
5-21 Event 1 standby action setting 5-43 Communication memory mode setting
5-22 Event 2 type setting 5-44 Communication mode type setting
5-23 screen 5-45 Keylock setting
5-23 screen
To Next Page
Loading...
