- 31 -
Screen No. Parameter (Item) / Screen Initial value Setting/Selection Remarks
5-0 Initial screen init. ( )
~
5-1 Pattern No. designation Ptn. ( )
l
5-2 Time designation tmUn. ( )
5-3
With/without power failure compensation
SAVE. ( )|~
5-4 Input abnormality code So. ( )
5-5 Measuring range rAnG. ( )|
hm
5-6 Input unit Unit. ( )
5-7 Input scale lower limit value Sc_L.
( ¦ )
rh
5-8 Input scale higher limit value Sc_H.
( ¦ )
ihrh
5-9 Input scale decimal point ScdP.
( )
rh
5-10 PV bias PV_b. ( ¦ )0 digit
5-11 PV filter PV_F. ( ¦ ) h
5-12 Output control characteristics Act. ( | ) |
5-13 Proportional cycle o_C. ( ¦} ) Y: P:kh k
5-14 Lower limit value of SV setting SV_L. ( ¦ ) rh
5-15 Higher limit value of SV setting SV_H. ( ¦ ) phrh
5-16 External control input 2 code di2c. ( j )
5-17 External control input 3 code di3c. ( k )
5-18 External control input 4 code di4c. ( l )
5-19 EV1 action type E1_m. ( ~i¦ )
5-20 EV1 hysteresis E1_d. ( ~i¦ )5 digit
5-21 EV1 standby setting E1_i. ( ~i¦ ) i
5-22 EV2 action type E2_m. ( ~j¦ )
5-23 EV2 hysteresis E2_d. ( ~j¦ )5 digit
5-24 EV2 standby setting E2_i. ( ~j¦ ) i
5-25 EV3 action type E3_m. ( ~k¦ )
5-26 EV3 hysteresis E3_d. ( ~k¦ )5 digit
5-27 EV3 standby setting E3_i. ( ~k¦ ) i
5-28 Status output 1 code do1c. ( i )
5-29 Status output 2 code do2c. ( j )
5-30 Status output 3 code do3c. ( k )
5-31 Status output 4 code do4c. ( l )
5-32 Analog output type Ao_m. ( |¦ )
5-33 Analog output scale lower limit Ao_L. ( |¦ ) rh
5-34 Analog output scale higher limit Ao_H. ( |¦ ) phrh
5-35 Communication mode comm. ( )
5-36 Communication protocol Prot ( )
5-37 Communication address Addr. ( | ) i
5-38 Communication speed bPS. ( ) ijhh
5-39 Communication data format dAtA. ( || ) o~i
5-40 Start character SchA. ( | )
5-41 BCC operation bcc. ( ) i
5-42 Delay time dELy. ( ~ ) jh
5-43 Communication memory mode mEm. ( ~ ) ~~
5-44 Communication mode type ComK ( } ) i
5-45 Keylock LocK. ( )
To Next Page
Loading...
Need help?
General
