Shure ADX5D - Page 22

Shure Incorporated
22/45
◦
◦
◦
Access Ctrl
Viewthestatusofaccesscontrol(enabledordisabled).Ifenabled,youcandisableaccesscontrolhere.UseWirelessWork
bench or other Shure control software to enable access control.
If access control is enabled, control applications such as Wireless Workbench and ShurePlus Channels supply a PIN in order
to remotely manage the device. That access control PIN appears in this menu. The initial PIN can be configured by Wireless
Workbench; see the Wireless Workbench help for more information on this.
Net Browse
Use the network browser utility to view all Shure devices on a network.
By Model
Arranges the network browser results by model name.
By FW Version
Arranges the network browser results by firmware version.
HW Identify
Send a hardware identification message to control applications, like Wireless Workbench, so you can locate your device in the
application.
Menu Lock
Use the locking feature to prevent accidental or unauthorized changes to controls and settings. Use the arrow buttons to
change the lock status of the menu.
Display
Brightness
Adjust the brightness of the display and LEDs. By default, ADX5D uses the ambient light sensor to automatically control
the brightness based on the environment.
Note: Lower brightness settings consume less power.
Timeout
Offers options to turn off display and front panel illumination after 30 seconds, 1 minute (default), 2 minutes, 3 minutes, or
5 minutes.
LEDs
Always On (default): All LEDs function normally.
Always Off: Antenna status, audio, and channel quality LEDs off. Power status and IR alignment LEDs continue to function
normally.
FollowDisplay:Antennastatus,audio,andchannelqualityLEDsfollowtheon/offbehavioroftheOLEDdisplay.Powersta
tus and IR alignment LEDs continue to function normally.
Dev Home Options
Select a device home screen.
Ch Home Options
Select a channel home screen.