41
Installation
Power the Hardware
① Audio Network Interface (ANI)
Connect the IEC power cable from the back panel to an AC power source. Turn on the power switch.
② Access Point Transceiver (APT)
Connect a shielded Cat5e cable from the MXWAPT to network Port 1 of the MXWANI. If using an external gigabit switch,
ensure Class 0 PoE provides at least 6.5W of power to the APT. There is no power switch.
③ Networked Charging Station (NCS)
Connect the PS45 external power supply from the charger to an AC power source. Turn on the power switch.
ௗ
7
8
6
5
1
2
3
4
7
8
6
5
1
2
3
4
7
8
6
5
1
2
3
4
Class 0 PoE
To Next Page
Loading...
