Shure Microflex Wireless - Using Multiple 2- or 4-Channel Access Points

66
Wireless Management
Using Multiple 2- or 4-Channel Access
Points
The MXW access point uses two sets of antennas to cover
the operating spectrum. Each antenna set covers half of
the timeslots used for MXW channels. Eight-channel units
use both antenna sets simultaneously; two- and four-
channel units use one set at a time, operating on half of the
available timeslots. The full spectrum can be covered they
are configured to alternating antenna sets.
When an installation uses multiple two- or four-channel
access points (APT2 or APT4), configure the access point
settings to maximize channel count. This is particularly
important for APTs that are mounted in the same or
neighboring rooms.
Mode A
Mode B
Mode A
Alternate Antenna Modes to use the Full Spectrum
Requirements
The MXW system must be operating on a minimum
firmware version of 2.0.0.