Shure Microflex Wireless - Automatic Group Setup

50
System Setup
Automatic Group Setup
An MXW Group can be associated without use of the control software when a network is comprised of only one Access
Point Transceiver (APT), one Networked Charging Station (NCS) and one Audio Network Interface (ANI). For best results,
perform a factory default on the devices to clear any previous Group associations.
7
8
6
5
1
2
3
4
Link
Power
7
8
6
5
1
2
3
4
link
6
5
1
2
link
+
7
8
6
5
1
2
3
4
lockout
power
ethernet
network audio
push to solo | hold to mute
-9
-18
-24
-36
-48
-60
0
-9
-12
-18
-24
0
aux
mic
adjust
line
sig/clip
mute
INPUT
A
sig/clip
mute
OUTPUT
HEADPHONE
Audio Network Interface
MICROFLEX WIRELESS
B
1
2
3
4
5
6
7
8
line
aux
push to solo | hold to mute
sig/clip
mute
INPUT
A
sig/clip
mute
OUTPUT
B
1
2
3
4
5
6
7
8
line
aux
6
7
8
9
10
11
12
1
2
3
4
5
6
7
8
9
10
11
12
1
2
3
4
5
5
7
8
6
5
1
2
3
4
i
i
i i
i
i
i
i
i
i i
i
i
i
i
i
i
i i
i
i
i
i
i
i i
i
i
i
i
i
i
i i
i
i
i
i
i
i i
i
i
i
i
i
i
i i
i
i
i
i
i
i i
i
i
i
i
INPUT
A
OUTPUT
B
1
2
3
4
5
6
7
8
lockout
power
ethernet
network audio
push to solo | hold to mute
-9
-18
-24
-36
-48
-60
0
-9
-12
-18
-24
0
aux
mic
adjust
line
sig/clip
mute
sig/clip
mute
HEADPHONE
MICROFLEX WIRELESS
line
aux
1. Connect one APT, one NCS and one ANI to the network. The network must only contain one of each device.
2. Perform a factory reset on the devices (see the Factory Default section).
3. On the front panel of the ANI, press both input level selection buttons at the same time and hold for five seconds. The
Channel Select LEDs will illuminate green and the audio meter will flash to indicate that the association is successful.