67
Wireless Management
Set Up
1. Open the MXW control software using the Shure Web
Device Discovery application.
2. Go to the Utility page.
3. Open the Device Properties window for the two- or four-
channel access point (MXWAPT2 or MXWAPT4).
4. Note that the APT is set to Mode A by
default (Device View > RF Mode Settings >
RF Coordination Mode). Close out of the window.
5. Open the Device Properties for the adjacent APT2 or
APT4.
6. Set the unit to Mode B (Device Propterties >
RF Mode Settings > RF Coordination Mode).
7. Select Add Updates to save the setting and close the
window.
8. Make sure any additional APTs are set to alternating RF
Coordination modes.
9. Select Apply All button on the Utility page to update all
device settings.
To Next Page
Loading...
