81
Software
All preferences apply to each device in the Configuration.
① Switch Behavior
Customize the switch on each transmitter type.
• Toggle (default): Press and release the button to change the
status to Active or Mute.
• Push-to-talk: Hold button to pass audio.
• Push-to-mute: Hold button to mute the audio.
• Disabled: The button does not affect the audio.
② Initial State from Charger
Assigns the state for the transmitter after it has been
removed from the charger:
• Active: On and passing audio to the network.
• Mute: On but the audio is muted.
• Standby: On but in a 'sleep' state with audio muted. Standby
conserves battery charge and enables a change to the
transmitter's status from the control software.
• Off: Power is off. A transmitter in this state cannot be
remotely controlled by the software.
③ LED Behavior
Set the behavior of the mute/active LED for each
transmitter type. Standby mode is always represented with
a pulsing red LED.
Active Mute
Solid Green* Solid Red
Solid Red Flashing Red
Solid Red Off
External LED Control
*Not available for MX400R series gooseneck microphones
④ Mute Preference
• Local Mute - Individual (default): Each transmitter is muted
individually.
• Local Mute - All: All transmitters mute when any transmitter
is muted.
• External Mute: Transmitter audio is on, and muted from a
3rd-party controller.
⑤ RF Power
Determines the RF coverage of an access point.
• Low: 25 ft (1mW)
• Medium: 50 ft (3 mW)
• Medium High: 100 ft (16 mW)
• Max: 150 ft (80 mW)
⑥ Out of Range Alarm
When enabled, a transmitter will audibly beep when it is
taken out of the RF coverage area. (Disabled by default.)
⑦ Back in Range Action
Transmitters can be set to automatically activate (default) or
mute when they re-enter the RF coverage area.
⑧ Standby Mode
• Local (default): Transmitter can individually be activated.
• Global: All transmitters are activated at the same time from
Standby mode.
⑨ Linking Preference
The Link procedure can be restricted to the control software
by disabling the hardware Link button on the Networked
Charging Station. By default, the Link button is enabled.
Preferences Tab
To Next Page
Loading...
