Shure MXA910-60CM - Audio and Performance Specifications

Shure Incorporated
56/59
AES67 or Dante Digital Output
Channel
Count
10 total channels (8 independent transmit channels, 1 Automatic mixing transmit channel, 1 AEC reference
in channel)
Sampling
Rate
48 kHz
Bit Depth 24
Sensitivity
at 1 kHz
0.75 dBFS/Pa
Maximum SPL
Relative to 0 dBFS overload
93.25 dB SPL
Signal-To-Noise Ratio
Ref. 94 dB SPL at 1 kHz
83 dB Aweighted
Latency (Not including Dante latency)
Direct outputs 6 ms
Automix output (Includes IntelliMix processing) 18 ms
Self Noise
11 dB SPLA
Dynamic Range
82.25 dB
Built-in Digital Signal Processing
MXA910 firmware
4.x or newer
Automatic mixing, Acoustic Echo Cancellation (AEC), Noise Reduction, Automatic Gain Control,
Compressor, Delay, Equalizer (4-band Parametric), Mute, Gain (140 dB range)
MXA910 firmware
3.x or older
Automatic mixing, Echo Reduction, Equalizer (4-band Parametric), Mute, Gain (140 dB range)
Intelligibility Scale
Equivalent acoustic performance, compared to a cardioid gooseneck microphone (environment dependent)
Cardioid distance multiplied by 1.6
1 Pa=94 dB SPL
Networking
Cable Requirements
Cat 5e or higher (shielded cable recommended)
[1]