Shure MXA910 - Page 77

Shure Incorporated
77/87
Get EQ Contour (firmware > v3.0)
Command String:
< GET EQ_CONTOUR >
MXA910 Response:
< REP EQ_CONTOUR sts >
Where sts takes on a value 1-4 to
indicate:
• 1 = OFF
• 2 = HIGH PASS
• 3 = LOW SHELF
• 4 = MULTI-BAND
Set EQ Contour (firmware > v3.0)
Command String:
< SET EQ_CONTOUR sts >
Where sts takes on a value 1-4 to
indicate:
• 1 = OFF
• 2 = HIGH PASS
• 3 = LOW SHELF
• 4 = MULTI-BAND
MXA910 Response:
< REP EQ_CONTOUR sts >
Get Network Audio Device Name
Command String:
< GET NA_DEVICE_NAME >
MXA910 Response:
< REP NA_DEVICE_NAME {yyyyyyyyyyyyyyyyyyyyyyyyyyyyyyy} >
Where
{yyyyyyyyyyyyyyyyyyyyyyyyyyyyyyy}
is a text string. Most devices allow
device id to be up to 31characters.
Value is padded with spaces as
needed to ensure that 31 char are
always reported.
Get Network Audio Channel Name
Command String:
< GET xx NA_CHAN_NAME >
Where xx is channel number All
channels: 0 MXA910: 1-9, 9 being
automix channel