17
8026957/AE00/V1-0/2021-08| SICK OPERATING INSTRUCTIONS | DUSTHUNTER SB30
Subject to change without notice
PRODUCT DESCRIPTION 2
Sender/receiver unit interfaces
The following interfaces are available directly on the sender/receiver unit.
2.2.2 Flange with tube
The flange with tube is available in different steel grades and dimensions (see “Flange with
tube”, page 65). Selection depends on the wall and isolation thickness of the duct wall
(
nominal length) and the duct material.
Fig. 7: Flange with tube
Analog output (1x)
0/2/4 ... 20 mA
Relay outputs
Load 48 V, 1 A
Digital input Service / MCU
interface
For output of
measurand dust
concentration
For output of status
signals:
● Operation/failure
● Limit value
● Warning/mainte-
nance/function
check (selectable)
E.g. for selection of
maintenance, function
check, linearity check,
calibration curve
switching, filter
monitoring synchronous
signal
For configuration with
SOPAS-ET or
connecting a MCU
NOTE:
A weather hood is mandatory when used outdoors. This prevents rainwater
from being sucked in (see “Weather hoods”, page 69).
NL
Marking for assembly position
Securing bolt
Material St 37 or 1.4571
To Next Page
Loading...