CONTENTS
3
8026957/AE00/V1-0/2021-08 | SICK OPERATING INSTRUCTIONS | DUSTHUNTER SB30
Subject to change without notice
1 Important information .............................................................................. 6
1.1 Main hazards...................................................................................................6
1.1.1 Hazard through hot and/or aggressive gases and high
pressure ..........................................................................................6
1.1.2 Hazards through electrical equipment ..........................................6
1.1.3 Hazards through laser beam.......................................................... 6
1.2 Symbols and document conventions .............................................................7
1.2.1 Warning Symbols ...........................................................................7
1.2.2 Warning levels and signal words.................................................... 7
1.2.3 Information symbols ....................................................................... 7
1.3 Intended use ................................................................................................... 7
1.4 Responsibility of user......................................................................................8
1.4.1 General information........................................................................8
1.4.2 Safety information and protective measures ................................8
2 Product description .................................................................................10
2.1 Measuring principle, measured variables....................................................10
2.1.1 Functional principle ......................................................................10
2.1.2 Response time ..............................................................................11
2.1.3 Function check..............................................................................12
2.2 Device components ......................................................................................13
2.2.1 Sender/receiver unit ....................................................................15
2.2.2 Flange with tube ...........................................................................17
2.2.3 Optional external purge air unit ...................................................18
2.2.4 Voltage and purge air supply........................................................18
2.2.5 Installation accessories................................................................18
2.2.6 Test equipment for linearity test..................................................19
2.3 SOPAS ET (PC program) ................................................................................19
3 Assembly and installation ......................................................................20
3.1 Project planning ............................................................................................20
3.2 Assembly .......................................................................................................22
3.2.1 Fitting the flange with tube ..........................................................22
3.2.2 Work to be performed...................................................................23
3.2.3 Fitting the optional external purge air unit. .................................23
3.2.4 Assembly work ..............................................................................24
3.2.5 Fitting the weather hood ..............................................................25
3.2.6 Fitting the optional MCU control unit ...........................................25
Contents
Contents
To Next Page
Loading...
Need help?
General