41
8026957/AE00/V1-0/2021-08| SICK OPERATING INSTRUCTIONS | DUSTHUNTER SB30
Subject to change without notice
START-UP AND PARAMETER SETTINGS 4
3 This message is shown:
4 “OK”
5 The Device Manager opens.
See: “Ports (COM & LPT)”
6 Now connect the MCU with the laptop/PC.
A new COM port is shown.
Use this COM port for communication.
4.2.6 Connection to the device via Ethernet (option)
Recommended procedure:
1 The MCU must be switched off.
2 Connect the MCU with the network.
3 Connect the PC to the same network.
4 Switch the MCU on.
To connect to the measuring system via Ethernet, the Ethernet interface module must
be installed on the MCU and the parameters set.
To Next Page
Loading...