SICK DUSTHUNTER SB30

32
8026957/AE00/V1-0/2021-08| SICKOPERATING INSTRUCTIONS | DUSTHUNTER SB30
Subject to change without notice
4 START-UP AND PARAMETER SETTINGS
4 Start-up and parameter settings
4.1 Fitting the sender/receiver unit
Assembly and installation must have been completed according to Section 3 before
starting the work described in the following.
4.1.1 Adapting the sender/receiver unit to the duct diameter
The sender/receiver unit is delivered with the short immersion depth (400 mm, see
“Relation between scattering angle, immersion depth (T) and measuring volume length (L)”,
page 16) set at the factory.
For duct diameters larger than approx. 3 m, we recommend converting the sender/receiver
unit to the long immersion depth (800 mm). The following steps are then necessary:
▸ Loosen CAMLOCK clips (1) of the sender/receiver unit, swivel electronics unit (2) to the
side and take off from mounting flange (3).
Fig. 18: Sender/receiver unit opened
The immersion depth set is displayed in the window for the measurement receiver (see
“Sender/receiver unit opened”, page 32).





CAMLOCK clips

Cover

Electronics unit

Plug connector

Mounting flange

Processor board

Fastening screw

Fastening screws