°
Screw the screws no more than 5mm into the threaded mounting holes or
sliding nuts.
°
To do so, either use all 4 threaded mounting holes on the rear of the product
or the two sliding nuts on the side of the product.
°
Attach the optional SICK mounting equipment ordered separately using the
sliding nuts on the product.
2. In application areas with severe vibrations or shocks caused by vibrations, jolts
or abrupt changes in directions (e.g., when mounted to a manned forklift truck),
mount the product with vibration dampers. Mount the product in a freely sus‐
pended manner.
3. Align the product taking into consideration the field of view and the application
circumstances.
4. Connect the product to interfaces and supply voltage when disconnected from
voltage.
5. Start the product.
✓
The Ready status LED lights up green.
6. Perform fine tuning.
MOUNTING 6
8029044/1MYO/2024-04 | SICK O P E R A T I N G I N S T R U C T I O N S | Inspector83x
31
Subject to change without notice
To Next Page
Loading...
