7.4 List of abbreviations (type-dependent)
Table 5: List of abbreviations
Display Meaning
1P 1-point teach-in
2P 2-point teach-in
AdC Automated threshold
Atch All teach-In
Auto Automated
Ch Channel
dAr Dark
dlY Delay
diSP Display switch
dYn Dynamic teach-in
Eco Energy-saving mode
Err Error
GAin Receiver amplification
Job Parameter sets
Job1 Parameter set 1
Job2 Parameter set 2
Job3 Parameter set 3
Job4 Parameter set 4
Job5 Parameter set 5
L--d Light/dark
LGt Light
LoAd Load
LocL Blocked
oFF Off
OUT Output
Pro Pro level (advanced settings)
rES Reset
SenS Sensitivity
Sto Store
tch Teach-in
thr Threshold
Turn Turn (display)
7.5 Defaults
The defaults specify the parameters required for operating the device. It is often the
case that only these parameters need to be set in order to use the device.
7.5.1 Teach-in
Several teach-in processes are available for configuring the device:
OPERATION 7
8023304.11XV/2018-11-29 | SICK O P E R A T I N G I N S T R U C T I O N S | KTL180
23
Subject to change without notice
To Next Page
Loading...
