SICK MITSUBISHI ELECTRIC MELSEC iQ-F Series - Chapter 8 Programming; Programming Procedure

8 PROGRAMMING
8.1 Programming Procedure
111
8
8 PROGRAMMING
This chapter explains the programming procedure for a safety control system.
System configuration example
In this chapter, program examples based on the following system configuration are explained.
8.1 Programming Procedure
The following shows the procedure for creating programs for running a safety control system.
1. Select a program to run on the safety extension module using a rotary switch.
2. Create a sequential program to run on the CPU module.
(1) CPU module (FX5U CPU module)
(2) Safety main module (FX5-SF-MU4T5)
(3) Safety input expansion module (FX5-SF-8DI4)
(4) Safety input expansion module (FX5-SF-8DI4)
(1) (2) (3)
(4)